Leica SE Instruções de Operação descarregar pdf (Página 48)

SHUTTER SPEED PRIORITY - T

Setting the mode

1. Set the shutter speed dial (1.11) to the desired exposure time.

2. Press the click wheel (1.18) to set automatic exposure control, i.e. in this

case shutter speed priority mode.

The lens aperture is then controlled automatically based on the available

light and continuously between a fully open and minimum aperture for the

relevant lens.

The viewﬁnder and top panel display show

• T (shutter speed priority) for the selected exposure mode (2.3.c/3.8)

• the automatically controlled aperture value (2.4/3.11)

• the manually set shutter speed value (2.2a/3.12)

Notes:

• If automatic sensitivity setting is activated at the same time (see p. 34), the

control range for shutter speed priority is extended.

By contrast, any maximum shutter speed set as part of the automatic sen-

sitivity setting is ineﬀective.

• With very little light or extreme brightness, the available aperture range of

the lens you are using may no longer be suﬃcient for the selected expo-

sure time. Set a diﬀerent shutter speed if possible. However, a correct

exposure is normally still achieved in such cases, by automatic setting of

the appropriate shutter speed, i.e. by "overriding" your manual selection.

(2.2b) may appear as a warning message to indicate that you are below

the metering range (see p. 41). It is then no longer possible to correctly

meter the exposure.

• If the shutter speed dial is set to

125

s) the camera switches to M

(see next section). As soon as a diﬀerent shutter speed is set, it switches

back to T.

MANUAL APERTURE AND SHUTTER SPEED

SETTING - M

Setting the mode

1. Set the shutter speed dial (1.11) to the desired value.

2. Press the click wheel (1.18) to set manual exposure control , i.e. in this

case manual mode.

3. Turn the click wheel (1.18) to set the desired aperture.

The viewﬁnder and top panel display show

• M for the selected exposure mode (2.3.d/3.8),

• the manually set aperture (2.4/3.11) and shutter speed values

(2.2a/3.12), and

• a light balance (2.6), which assists in adjusting the exposure.

The light balance shows the deviation of the set shutter speed/aperture

combination from the metered exposure value. The display clearly shows the

range ±3 EV in

EV steps. Larger deviations are shown by ﬂashing of the

outer markings on the light balance.

To achieve the correct exposure according to the result of the exposure

metering, the aperture and/or shutter speed should be adjusted until the

zero marking lights up on the light balance.

Notes:

• If automatic sensitivity setting is activated at the same time (see p. 34), the

last manually set sensitivity is used.

• Any maximum shutter speed set as part of the automatic sensitivity setting

has no eﬀect.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 76 77

Comentários a estes Manuais

Sem comentários

Leica SE Instruções de Operação Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Leica SE