
20
Preparing the charger
For use outside the USA
1. Insert the appropriate plug for the local mains supply into the charger (B).
This is done by simultaneously
a. pushing the release button (1.49a) upwards, and
b. pushing up the plug (1.49) from its idle position.
2. It can then be completely detached upwards.
3. The appropriate plug type is then pushed into the charger from above until
it engages.
For use in the USA
1. Detach the factory fi tted mains plug (C) from the charger (B). This is done
by simultaneously
a. pushing the release button (1.49a) upwards, and
b. pushing up the plug (1.49) from its idle position.
2. You can then fold out the two pins for the US plug (1.49b), which are
pushed down into the normal position.
Notes:
• The charger automatically switches to the prevailing mains voltage.
• When using the car charging cable supplied, the charger can be used in all
vehicles with a 12V or 24V on board supply. It automatically switches to
the relevant voltage.
CONNECTING THE CHARGER
1. Connect the charger (B), i.e. plug it (1.45a) into the socket on the battery
(1.44) and connect the mains plug (1.49/1.49b) to an outlet.
• To con rm that charging is in progress, the green LED labeled
CHARGE
(1.47) starts fl ashing.
As soon as the battery is charged to at least
4
/
5
of its capacity, the orange
LED labeled
80% (1.46) also lights up. When the battery is fully charged,
i.e. 100% capacity has been reached - after around 3
1
/
2
hours – the green
CHARGE-LED is continuously lit.
Notes:
• The
80% LED lights up after around 2 hours due to the charging character-
istics. Therefore, if you do not need the full capacity, the camera is always
ready to use again in a relatively short time.
• If the green
CHARGE LED is continuously lit, this indicates that the charger
has automatically switched to trickle charging.
2. The charger should then be disconnected from the mains. However, there
is no risk of overcharging.
Comentários a estes Manuais