Leica SE Instruções de Operação descarregar pdf (Página 13)

DISPLAYS

2. In the viewﬁnder

2.1 Horizon

(tilt about longitudinal axis / gradient about transverse axis; exam-

ple displays apply to clockwise gradient; other directions are indi-

cated accordingly)

max. ±0.5°

0.5-2.5°

2.5-5°

5-10°

Flashing ≥10°

2.2 Shutter speed / exposure time

a. Manually set value for

and , automatically controlled value for

and ; display in half steps, or

(high) or (low) for over or under exposure in automatic

exposure modes

, , and due to ﬂash, or if below the

metering range.

B setting for long-time exposure

Full memory card warning message

2.3 Exposure mode

= Programmed automatic exposure mode

= Aperture priority

= Shutter speed priority

= Manual shutter speed and aperture setting

2.4 Aperture, manually set value for

and , automatically controlled

value for

and ; display in half steps

2.5 Flash displays

Lit = Flash ready,

Flashing = Flash charging, ﬂash is not ready

Lit = Shutter speed ≥ Sync speed set

2.6 Light balance

(markings:

EV step each, last markings/

numbers ﬂash at ≤-3EV/≥+3EV ) to indicate

a. Manual exposure compensation,

b. Variation between current metered value and stored exposure

setting (with metering memory lock in automatic exposure modes

, , )

c. Exposure compensation

2.7 Focus displays

Only appears in manual mode or with manual AF override: Con-

tinuously lit if setting is too long

In manual mode: Continuously lit if setting is correct

- For

AFs: Continuously lit if setting is correct, ﬂashes if correct

setting is not possible,

- For

AFc: Continuously lit if setting is correct, goes out if focus-

ing procedure is restarted,

Only appears in manual mode or with manual AF override: Con-

tinuously lit if setting is too short

2.8 Indicates exposure compensation /

ﬂash exposure compensation set

2.9 Metering method symbol

= Multiple ﬁeld metering

= Center-weighted metering

= Spot metering

2.10 Frame counter

= Total pictures remaining

= External storage

(ﬂashing at 2 Hz) = Memory card full

(ﬂashing at 2 Hz) = No memory card inserted

= Maximum number for series exposures

= Error message

2.11 Sensitivity displays

For manual setting

For automatic setting

Current sensitivity setting

Note:

The viewﬁnder LCD is always lit when the camera is on (see "Turning on the

camera, page 25). The brightness of this illumination is automatically adjust-

ed to the external lighting conditions to give optimum readability.

2.2 2.32.1 2.6 2.5b

2.7

2.9 2.10 2.11c

2.11a/b

2.4 2.6 2.8 2.11b

2.5a

a b c

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 76 77

Comentários a estes Manuais

Sem comentários

Leica SE Instruções de Operação Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Leica SE